My first experience with PV360 was the dump truck, and the resulting image wasn’t very satisfying. Now a few months later I’m trying it again, and I find myself learning rendering…
So much of what SolidWorks users assume about assembly modeling appears to come from the official SolidWorks training. The official SW training has been around for a good long time, and it receives high…
The web is stirring with a lot of writing about the change in management at SolidWorks: original press release -Bertrand Sicot Named CEO of Dassault Systèmes SolidWorks Corp. Jeff Ray blog…
These are the 10 posts that got the most traffic during the year of 2010. They weren’t all written in 2010, but they must have been the most relevant for…
This is a comparison of the tools in SolidWorks and Solid Edge for advanced surface modeling work. This is the type of work that I do most in my day job. I’m learning the SolidEdge tools as I…
Again, here are the disclaimers. This is a comparison primarily to familiarize SolidWorks users with Solid Edge sheet metal. I am not a sheet metal genius. I’m certified in SW sheet metal, but that just means I…
Instead of files. The title of this post is a question for a reason. I don’t know much about databases, even though my blog and my email are both run…
Ken Baker left a suggestion on the Topic Suggestion page. I prefer working on technical problems as opposed to writing about crap like clouds or whatever. So if you send…
Just as a warning, there is a lot to say on this topic, and this is going to be a huge post. Maybe you should read it in chunks, but…
Solid Edge ST3 combines direct modeling and history functionality into the same part. In the past, you had either a synchronous part or a “traditional” part (they are dropping the word “traditional”…